International Journal of Material Science and Electronics Research (IJMSER) is an international journal published two times per a year, covers theoretical and experimental, in the realm of solid state physics, solid state chemistry and material science.
Aim and Scope: International Journal of Material Science and Electronics Research (IJMSER) is devoted to full-length research papers and review articles on characterization, processing, properties and performance of materials. The Editors welcome manuscripts on semiconductors and electronic materials, alloys, metals, composite materials, ceramics, oxide materials, glasses solids, superconductors, inorganic materials, organic semiconductors and polymers, thin films, nano-materials, solid state, solidification, thermal evaporation, sputtering, vapour deposition and other deposition methods, electronic devices; metal-organic-inorganic semiconductor device, organic solar cell, organic-inorganic device, organic light emitting diode, metal–insulator–semiconductor structures, organic-organic thin film transistors, sensors, photovoltaic devices.
Submission of Manuscripts:
International Journal of Material Science and Electronics Research (IJMSER) is a refereed journal. The manuscript should be submitted to the Editor-in-Chief or to an appropriate member of the Editorial Board. In order to minimize the time involved in reviewing process, authors must provide a list of three knowledgeable reviewers’ names in the area with full postal and email addresses. The electronic version should be prepared using LaTex, MS Word, or WordPerfect. All accepted manuscripts, artwork, and photographs become the property of the publisher. All parts of the manuscript should be typewritten, double-spaced, with margins of at least one inch on all sides. Number manuscript pages consecutively throughout the paper. Each article should be summarized in an abstract of no more than 100 words. Avoid abbreviations, diagrams, and reference to the text.
All manuscripts should be addressed to the Editor
Editor-in-Chief, IJMSER
Fahrettin YAKUPHANOGLU
Department of Physics
Facultys of Arts and Sciences
Fırat University, 23119, Elazığ, TURKEY
E-mail:fyhanoglu@firat.edu.tr, fyhan@hotmail.com
Tel:+904242370000-3621
Fax:+904242330062
References: References should be listed at the end of the paper, and numbered in the order of their appearance in the text. Authors should ensure that every reference in the text appears in the list of references and vice versa. Numerals for references should appear in square brackets [], and any reference to authors' names in the text should omit initials. In the reference list, periodicals [1] and books [2], should be cited as in the following examples:
[1] S.E. Shaheen, C.J. Brabec, N.S. Sariciftci, Appl. Phys. Lett. 78 (2001) 841.
[2] E.H. Rhoderick, R.H. Williams, Metal-Semiconductor Contacts, second ed., 1988.
Language:
The manuscript must be written in normal English.
Keywords:
Authors should supply up to five key words along with their manuscript and should be indicated below the abstract.
General Format of the manuscript: Manuscript of the paper should be in English and the following format/order should be adopted.
1. Title
2. Author/authors
3. Affiliation and e-mail
4. Abstract (not more than 100 words)
5. Key Words (primary and secondary)
6. Introduction
7. Experimental section
8. Results and discussion
9. References
Disclaimer
This publication contains information obtained from authentic and highly regarded sources. Reasonable effort has been made to publish reliable data and information, but the author and the publisher cannot assume responsibility for the validity of all materials or for the consequences of the use.
All rights reserved. No part of this publication may be reproduced, stored in a retrieval system or transmitted, in any form, or by any means, electronic, mechanical, photocopying, recording or otherwise, without prior permission, in writing, from the publisher or the author.
